1.5 m2 Condenser HTA Distillation Column for CBD / THC / Hemp oil / Cannabissativa
——Particular features
Continuous distillation process.
Low operating pressures (100~10000Pa ,100Pa=1mbar).
Short residence time.
High evaporation rates.
Processing of high-boiling, high-viscosity or crystallizing products is possible.
Can be used as a reboiler for column.
Low fouling on evaporator wall.
| Type | JZ-80 |
| Material | stainless steel 304/S316L |
| Distillation column type | packed tower |
| Theoretical plate | 10-20 |
| Temperature | Room temp~200/300 ℃(depend on the oil heater) |
| Column size | DN80*800-1600mm |
| Reboiler | 30L-50L |
Receiver
size&quantity | 10Lor20L*2 |
| Condenser HTA | 1.5 (m2) |
| Vacuity | MIN:1mbar(depend on the nature of material and vacuum pump&vacuum pump not included) |
| Floor area | length*width*height=1000*800*2700-3500 (mm) |
| Power | 1.1KW(without pump) |
| Voltage | 220V-60HZ |
| Warranty | 12 Month |
Distillation columns are made up of several components, each of which is used either to tranfer heat energy or enhance materail transfer. A typical distillation contains several major components:
a vertical shell where the separation of liquid components is carried out
column internals such as trays/plates and/or packings which are used to enhance component separations
a reboiler to provide the necessary vaporisation for the distillation process
a condenser to cool and condense the vapour leaving the top of the column
a reflux drum to hold the condensed vapour from the top of the column so that liquid (reflux) can be recycled back to the column
The vertical shell houses the column internals and together with the condenser and reboiler, constitute a distillation column. A schematic of a typical distillation unit with a single feed and two product streams is shown below:
Product Tags:
|
|
Stainless Steel 304 Fractional Distillation Tower / Chemical Distillation Equipment Images
|
